Arctic Cat BEARCAT F5, Operator'S Manual

Page: 57 / 72

53
Removing and Installing
Taillight/Brakelight Bulb
(Bearcat 570/T570/TZ1)
1. Remove the torx-head cap screws
securing the taillight access panel.
742-467A
2. Disconnect the harness connector
and remove housing.
3. Push in on the socket and rotate it
counterclockwise to remove it from
the housing.
4. Remove the old bulb by pulling it
straight out of the socket.
5. Install the new bulb in the socket by
pushing it straight in.
6. Push the socket into the housing and
rotate it clockwise to lock into place.
7. Connect the harness connector.
8. Secure the access panel with the
torx-head cap screws.
Removing Headlight Bulb

NOTE: The bulb portion of head-
light is fragile. HANDLE WITH CARE.
When replacing the headlight bulb,
the bulb assembly must first be
removed from the housing. Do not
touch the glass portion of the bulb. If
the glass is touched, it must be
cleaned with a dry cloth before
installing.
To access the headlight bulbs, use the fol-
lowing procedure:
1. Remove the two torx-head screws
located to the outside of the head-
light adjustment knobs; then remove
the single torx-head screw from
beneath the console (located
between the headlights).
743-439A
2. Remove the cap screw and lock nut
securing the front of the headlight
assembly to the air-intake silencer.
3. Lift the front of the console enough
to allow the headlight housing to be
removed; then remove the housing.
4. Remove the bulb from the headlight
housing and disconnect the wiring
harness from the bulb.
741-329A
Installing Headlight Bulb
1. Plug the wiring harness into the
headlight bulb.
2. Insert the bulb into the headlight
housing.
3. Lift the front of the console enough
to allow the headlight housing to be
installed; then install the housing
making sure the forks of the housing
go into the grommets on top of the
air-intake silencer. Secure with the
cap screw and lock nut.
CAUTION
Do not touch the glass portion of the
bulb. If the glass portion is touched, it
must be cleaned with a dry cloth
before installing.