Arctic Cat BEARCAT F5, Operator'S Manual

Page: 46 / 72

42
IO001A
ZJ306A
IO121A

NOTE: On the 1100 cc, there are
spare fuses inside the fuse panel.
IO002A

NOTE: On the Bearcat Z1 XT GS,
the towing accessories fuses are
located beneath the seat.
2. Remove the suspected fuse.
3. Look through the clear side of the
fuse to see if the element inside is
burned or separated. If it is, the fuse is
blown and should be replaced with a
fuse of the correct amperage rating.
4. On the 1100 cc, install the fuse panel
cover and close the right-side access
panel. On the F5/570 cc, install the
fuse holder cover.
Even after replacing a fuse, it may con-
tinue to blow if the cause of the overload
is not determined. If the fuse continues to
blow, take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer for
service. If not under warranty, this ser-
vice is at the discretion and expense of
the snowmobile owner.
Brake System
Arctic Cat recommends that the brake
system (brake lever, fluid reservoir, hose,
caliper, pads, and brake disc) be checked
daily for fluid leakage, wear, or damage
and for proper operation. Also, the brake
fluid level must be checked every time
before starting the engine. The brake
fluid must be visible in the sight glass.
Checking/Adding Brake
Fluid
1. With sight glass reservoir in a level
position, check the fluid level. The
brake fluid level must be visible in
the sight glass.

NOTE: If the sight glass appears
dark, there is a sufficient amount of
fluid in the reservoir.
1100 cc
F5/F570
Bearcat 570/T570
! WARNING
Always replace a fuse with one hav-
ing the same specified amperage rat-
ing. Using a fuse with a higher rating
can cause severe wire damage and
could start a fire.
! WARNING
DO NOT operate the snowmobile
when the brake lever lock is engaged
or when any component in the brake
system is damaged, worn, or
adjusted improperly. If the snowmo-
bile is operated and the brake system
is not functioning properly, severe
personal injury could result.