Arctic Cat BEARCAT F5, Operator'S Manual

Page: 15 / 72

11
At this point, the hours display will begin
to flash. Push the increment button to
increase the hours; push the decrement
button to decrease the hours. Pushing and
holding a button will accelerate the num-
ber display. When desired hour number is
displayed, push the select button.
At this point, the minutes display will
begin to flash. Push the increment button
to increase the minutes; push the decre-
ment button to decrease the minutes.
Pushing and holding a button will accel-
erate the number display. When desired
minute number is displayed, push the
select button.

NOTE: During clock setting if no
button (increment, decrement,
select) is pushed within a 5-second
time period, the clock-setting mode
will be exited with changes saved.

NOTE: The altimeter readout is
based off barometric pressure and
may require calibration as weather
conditions change.
To set/calibrate the altimeter to an estab-
lished altitude with altimeter selected on
the display screen by pushing and hold-
ing the select button for a minimum of
two seconds, the acronym CAL will be
displayed on the readout screen for one
second; then the altitude value will flash.
Push the increment button to increase the
displayed altitude; push the decrement
button to decrease the displayed altitude.
Pushing and holding a button will accel-
erate the number display.

NOTE: If MPH has been selected in
the speed readout, the altitude value
will be displayed in feet. If kph has
been selected in the speed readout,
the altitude value will be displayed in
meters.
To reset the maximum altimeter readout
with the maximum altimeter displayed,
push and hold the select button for a min-
imum of two seconds.
Service Icon
On electric start models, the icon should
illuminate each time the key is turned to
RUN or START, and it should go out
when the engine starts. If the icon stays
illuminated (on electric start models) or it
illuminates while the engine is running,
the system is receiving input that is out-
side of its established parameters. If the
icon illuminates indicating an error, take
the snowmobile to an authorized Arctic
Cat Snowmobile dealer for service. If not
under warranty, this service is at the dis-
cretion and expense of the snowmobile
owner.
Coolant Temperature
Warning Icon (Bearcat Z1
XT LTD/TZ1 LXR)

NOTE: When cold-starting the
engine, the coolant temperature
warning icon will illuminate, the
readout screen will display TEMP,
and engine RPM limit will be below
drive system engagement speed.
When the engine reaches proper operat-
ing temperature, the coolant temperature
warning icon and TEMP display will
cease to flash.
If the coolant temperature rises too far
above proper operating temperature, the
coolant temperature warning icon will flash
a warning (alert) the engine will “surge” to
alert the operator. If the coolant temperature
rises to a critical point above proper operat-
ing temperature, the coolant temperature
warning icon will cease flashing and will
remain constantly illuminated.

NOTE: If the coolant temperature
icon is constantly on, the engine will
shut off if vehicle speed is reduced
to 1.5 kph (0.9 MPH) or slower.
CAUTION
At this point, take precautionary mea-
sures such as changing to loose snow
terrain, shutting the engine off (allow-
ing the engine to cool down), and
checking coolant level. If unable to
either determine or remedy the prob-
lem, take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer for
service. If not under warranty, this ser-
vice is at the discretion and expense of
the snowmobile owner.