52
KM685A
7. Install the high gear clutch dog and flat washer. At
this point, the countershaft is ready for installation.
KM684
8. Install the low driven gear washer on the driveshaft;
then install the low driven gear and thrust washer.
Secure with a snap ring.
KM692A
9. Install the low/reverse clutch dog and spacer washer;
then install the reverse gear and reverse gear thrust
washer. At this point, the driveshaft is ready for
installation.
KM690A
10. Apply clean engine oil to the assembled shafts and
gears; then install the countershaft and driveshaft
simultaneously into the transmission case.
KM699
11. Install the low/reverse shift fork into the low/reverse
clutch dog; then install the shift cam into the trans-
mission case and engage the shift fork pawl in the
appropriate shift cam groove.
KM700
12. Install the high shift fork into the high clutch dog;
then engage the shift fork pawl into the appropriate
shift cam groove.
13. Install the shift fork shaft making sure that the shift
fork pawls remain engaged in the shift cam; then
install the shift cam stopper ball, spring, seal/washer,
and plug (threads coated with red Loctite #271).
Tighten to 20 ft-lb.
Manual
Table of Contents
For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
