47
B. Water Pump
C. Trigger Coil
D. Stator Coil
E. Rotor/Flywheel
14. Remove the right crankcase cover (see Fuel/Lubrica-
tion/Cooling - Water Pump).
15. Remove the trigger coil mounting screws; then
remove the wire set plate.
KM772A
16. Remove the three cap screws securing the stator coil
to the crankcase cover; then remove the stator coil
and trigger coil.
17. Remove the oil-through and spring from the end of
the crankshaft; then hold the rotor/flywheel with an
appropriate holding tool and remove the flywheel nut
and washer.
KM774
18. Install the flywheel puller and crankshaft protector;
then remove the rotor/flywheel. Account for a key
and the starter one-way clutch bearing.
KM775
KM766A
NOTE: The starter one-way clutch bearing is direc-
tion oriented and will only function if installed prop-
erly. Note the markings or arrows when removed.
F. Oil Pump
NOTE: Steps 14-18 in the preceding sub-section
must precede this procedure.
19. Remove the rotor/flywheel (see Rotor/Flywheel in
this sub-section).
20. Remove the starter drive gear and place together
with the rotor/flywheel to keep the one-way clutch
bearing intact.
KM767A
AT THIS POINT
To remove/service the water pump, see Fuel/Lubrica-
tion/Cooling.
CAUTION
Use extreme care to avoid damaging or shorting the
wiring.
AT THIS POINT
To service the stator coil, see Electrical System.
AT THIS POINT
To service the trigger coil, see Electrical System.
Manual
Table of Contents
For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
