36
KM408
NOTE: Do not remove the spiral spring unless
replacement is necessary. It should be visually
inspected in place to save time. If replacement is nec-
essary, follow steps 6-7.
6. Remove the spiral spring from the case by lifting the
spring end up and out. Hold the remainder of the
spring with thumbs and alternately release each
thumb to allow the spring to gradually release from
the case.
7. Unwind the rope from the reel and remove the rope.
Cleaning and Inspecting
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all components.
2. Inspect the springs and ratchet for wear or damage.
3. Inspect the reel and case for cracks or damage.
4. Inspect the shaft for wear, cracks, or damage.
5. Inspect the rope for breaks or fraying.
6. Inspect the spiral spring for cracks, crystallization, or
abnormal bends.
7. Inspect the handle for damage, cracks, or deteriora-
tion.
Assembling/Installing
1. If removed, insert the spiral spring into the case with
the outer end of the spring around the mounting lug
in the case; then wind it in a counterclockwise direc-
tion until the complete spring is installed.
NOTE: The spiral spring must seat evenly in the
recoil case.
KM402
2. Insert the rope through the hole in the reel and tie a
knot in the end; then wrap the rope clockwise around
the reel leaving approximately 50 cm (20 in.) of rope
free of the reel.
3. Apply low-temperature grease to the spring and hub.
4. Thread the end of the rope through the guide hole of
the case; then thread the rope through the handle and
washer and secure it with a double knot. Install the
protective cover into the handle.
KM400
KM405
5. Align the inner hook of the spiral spring with the
notch in the reel spacer.
Manual
Table of Contents
For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
