21
RECOIL STARTER AIR
VENTS
It is important for proper engine cooling
that the air vents located on the recoil
starter are kept clean. These air vents
should be checked periodically and
cleaned if necessary.
725-573B
LIGHTS
The correct headlight bulb is p/n 0609-
004. The correct taillight bulb is p/n
0230-020. The taillight bulb is accessi-
ble from inside the rear storage com-
partment. It is not necessary to remove
the taillight assembly in order to change
the bulb.
To change the headlight bulb, use the
following procedure:
1. Open the hood; then remove the
rubber boot from the bulb socket.
2. Remove the socket from the hous-
ing by rotating it counterclockwise
until loose.
3. Remove the bulb from the socket
by pressing the bulb in and rotating
it counterclockwise until loose.
4. Install the new bulb; then install
the socket into the housing.
5. Install the rubber boot onto the
socket; then close and secure the
hood.
The headlight aim can be adjusted to
provide maximum illumination for the
operator. To adjust headlight aim, adjust
the four headlight adjustment screws
until maximum illumination for the
operator is apparent.
! CAUTION
Serious overheating of the engine
and engine damage will result if
the air vents are not kept clean.
Summary of Contents for AC 120 2007
Page 28: ...24 SNOWMOBILE SAFETY RULES...
Page 30: ...26 NOTES...
Page 39: ...30 REMARQUES...
