2-14
To check/add coolant, use the following procedure.
1. Check the level of coolant in the coolant expan-
sion tank located under the right front fender. The
coolant level should be between the Full Cold and
Full Hot lines.
DE019A
2. Remove the rubber plug from the neck of the cool-
ant expansion tank and add coolant as necessary;
then install the plug.
3. Remove the filler cap and add coolant as necessary
to bring coolant level to the top of the filler neck.
Install and tighten the filler cap.
DE582A
Checking/Replacing
V-Belt
REMOVING
1. Remove the right-side footrest (see Section 8).
2. Remove the cap screws securing the V-belt cover;
then using a rubber mallet, gently tap on the cover
tabs to loosen the cover. Remove the cover.
3. Remove the cap screw securing the drive clutch to
the flywheel stub axle; then remove the nut and
lock washer securing the movable drive face to the
fixed drive hub.
DE093A
DE095
4. Remove the movable drive face using care to keep
the face plate tight against the drive face to prevent
the weights from falling out. Account for a spring
seat, spring, bushing, and lock washer.
DE096A
DE094A
Back to TOC
Back to Section TOC
Next
Back
