72
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all swing arm components in parts-cleaning
solvent.
2. Inspect all swing arm welds for cracks or unusual
bends.
3. Inspect all tubing for cracks or unusual bends.
4. Inspect the pressed-in bushings for damage.
5. Inspect the rubber swing arm guard for damage.
6. Inspect the seals for damage.
INSTALLING
1. Lubricate the pressed-in swing arm bushings with a
light coat of grease; then install the spacer into the
swing arm.
2. If removed, install the rubber swing arm guard.
3. Lubricate the two seals with a light coat of grease;
then install them on the ends of the swing arm.
4. Position the swing arm in the frame and slide the
long cap screw through the brackets and swing arm.
MD2007
5. Install the washer and self-locking nut. Tighten the
nut to 50 ft-lb.
6. Install the axle, spacers, hubs, and drive chain (see
Rear Hub/Drive Axle in Drive System section).
7. Secure the shock absorber to the swing arm with the
cap screw. Tighten the cap screw to 29 ft-lb.
MD2315
8. Place the rear chain guard and skid plate into posi-
tion and install the cap screws; then tighten the cap
screws securely.
MD2014
9. Place the axle housing into position on the swing arm;
then install and tighten four cap screws to 29 ft-lb.
10. Install the brake caliper on the axle housing with the
two cap screws. Tighten securely.
KM229
11. Install the wheels and tighten the cap screws to 30 ft-
lb; then remove the ATV from the support stand.
Wheels and Tires
TIRE SIZE
The ATV is equipped with low-pressure tubeless tires of
the size and type listed (see General Information section).
Do not under any circumstances substitute tires of a dif-
ferent type or size.
CAUTION
Do not tighten the cap screw beyond the 29 ft-lb specifi-
cation or the shock eyelet or mount WILL be damaged.
! WARNING
After removing and installing of brake-related compo-
nents, ALWAYS check and adjust brakes as necessary
before operating the ATV.
! WARNING
Use only Arctic Cat approved tires when replacing tires.
Failure to do so could result in unstable ATV operation.
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
