4-9
4
2. Turn the idle adjustment screw clockwise one turn
past the recommended RPM setting; then turn it
counterclockwise to 1250-1350 RPM.
PR081A
Gas Tank
REMOVING
1. Remove the seats and center console; then remove
the left-side and right-side seat-bases.
2. Remove twelve cap screws and two self-tapping
screws securing the floorboard to the frame.
3. While pulling forward on the upper portion of the
floorboard, lift the rear panel above the seat lock
studs; then insert a small wood block to hold in
position.
PR163
PR164
4. From the opposite side of the vehicle, repeat step
3; then lift the rear of the floorboard up and lift the
floorboard out of the vehicle.
PR165
5. Disconnect the vent hose, gas hose, and fuel level
sensor connector; then cap the vent fitting and gas
hose fitting.
PR166B
6. Remove the outer cap screw securing the front tank
hold-down; then swing the hold-down to the left.
! WARNING
Adjust the idle to the correct RPM. Make sure the
engine is at normal operating temperature before
adjusting the idle RPM.
! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
Back to TOC
Back to Section TOC
Next
Back