31-DVIE33C
19
SURROUND INSTALLATION
Surround options available are dependent upon the control
panel configuration. (See Control Panel Locations regarding
configuration.) Shallow surround options are not available on
a unit with ‘Controls Out’ configuration.
Make sure the gas and electrical lines are properly connected
to the appliance. Slide the unit into the fireplace and slide the
excess flue liner material back onto the chimney. Before the
appliance is fully recessed into the fireplace, attach the sur-
round onto the appliance.
Attach the surround to the appliance at the locations shown by
lining up the tabs on the surround with the slots on the unit.
Make sure the surround drops down and fully engages. Then
finish with the wiring connection to the on/off switch on the
side of the trim. Now fully “seat” the unit into its final position.
Care must be taken that Trim Panels or Surrounds shall not
seal ventilation openings in the fireplace.
Surround Mounting
tabs
Fig. 19-B
Fig. 19-A
Fig. 19-C
A T T E N T I O N
Main On/Off switch must be connected to the surround switch
and in the “on” position for the remote to operate the fireplace
Surround Mounting slots
Restrictor installed
in upper baffle.
Center air channel
is closed off with
restrictor
Firebox baffle w/out
restrictor.
All three air channels
in the baffle are open
VENT RESTRICTOR INSTALLATION
When the vent is over 18’(5.5m) a vent restrictor may be required. The installation of the restrictor will equalize the vent
stack action that can cause problems with a proper fire set-up.
The vent restrictor is supplied loose in the manual bag. When required, it installs onto the upper baffle in the center portion.
The baffle air openings are located in the top of the firebox just inside the front frame of the fireplace. There are holes al-
ready in the standoffs that will line up with the holes in the restrictor.
Upper Baffle
air channels
Upper Baffle
