Last Rev Date: 25/06/19
Page 9 of 14
Fitting instructions# 3789337
Copyright © 2019 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
17. Adjust the control box until it is approximately
5mm clear of front of control box recess and
tighten all fasteners.
M6 - 9
Nm.
Control Box Assembled;
Rear view shown
Smittybilt “GEN 2” winches
. Requires Smittybilt
adapter kit 3500770
18. Mount the Control Box to the adapter bracket
included in the 3500770 kit using the M5
hardware provided in the kit.
19. Mount the control box to the 3759658 bracket
in this kit using 2x M6x25 bolts, flange nuts
and washers removed in Step 2, passing the
control box cables past the cut-out at the rear
of the bracket.
Rear view shown.
NOTE:
ENSURE THE CUT-OUT EDGES OF THE
BRACKET FACE THE
REAR
OF THE BAR AS
SHOWN
20. Mount the control box sub-assembly and
cable guard plate to the bar using the 4x
M6x25 bolts, flange nuts and washers
included in this kit.
Rear view shown.
HINT:
Apply some split cable protection
conduit to the winch cables where they
pass through the Bull Bar then route and
cable tie them clear of the winch spool.
