Last Rev Date: 25/06/19
Page 5 of 14
Fitting instructions# 3789337
Copyright © 2019 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
1.
Lay the bar face down on a soft surface so as
not to damage the paint / powder coat.
2.
If fitted, carefully remove the winch cover
plate and discard. Keep fasteners for re-use.
Warn Zeon / Platinum winches:
3.
Mount the Control Box to the winch cradle
using 4x M6x25 hex head bolts, washers and
spacers provided with this kit.
4.
Adjust the control box until it is approximately
5mm clear of front of control box recess and
tighten all fasteners.
M6 - 9
Nm.
5.
Route and cable tie the Control Box Cables
clear of the winch spool area.
Control Box Assembled;
Rear view shown
HINT:
Apply some split cable protection
conduit to the winch cables where they
pass through the Bull Bar.
