Last Rev Date: 25/06/19
Page 8 of 14
Fitting instructions# 3789337
Copyright © 2019 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
Warn Magnum winches (“GEN 2”):
12. Mount the Control Box to the Warn Mount
Plate using the fasteners supplied with the
winch kit, ensuring that the 2x centrally
located M6 hex head bolts pass through the
plates as shown.
13. Adjust the control box until it is approximately
5mm clear of front of control box recess and
tighten all fasteners.
M6 - 9
Nm.
14. Route and cable tie the Control Box Cables
clear of the winch spool area.
Control Box Assembled;
Rear view shown
Warn M8000, XD9 & 9.5XP “Contactor” control
box winches.
15. Mount the control box to the 3759658 bracket
in this kit using 2x M6 flange nuts provided,
passing the control box cables past the cut-
out at the rear of the bracket.
Rear view
shown.
NOTE:
ENSURE THE CUT-OUT EDGES OF THE
BRACKET FACE THE
REAR
OF THE BAR AS
SHOWN
16. Mount the control box sub-assembly and
cable guard plate to the bar using the 4x
M6x25 bolts, flange nuts and washers
included in this kit.
HINT:
Apply some split cable protection
conduit to the winch cables where they
pass through the Bull Bar then route and
cable tie them clear of the winch spool.
