Last Rev Date: 25/06/19
Page 11 of 14
Fitting instructions# 3789337
Copyright © 2019 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
Bushranger REVO winches “GEN 2”.
27. First remove the plastic control box cover
then align the two slots in the base with the
slots in the bar mount. Use at least 2x hex
head M8x20 bolts, washers and nuts to
secure the control box (
not provided
).
28. Carefully replace the plastic control box cover
and adjust the control box until it is
approximately 5mm clear of front of control
box recess and tighten the M8 fasteners.
M8 - 22
Nm.
29. Mount the cable guard plate to the bar using
2x M6x25 bolts, flange nuts and washers
included in this kit.
Rear view shown.
M6 - 9
Nm.
Control Box Assembled;
Rear view shown
HINT:
Apply some split cable protection
conduit to the winch cables where they
pass through the Bull Bar then route and
cable tie them clear of the winch spool.
