English
With gentle pressure, rotate the pressure plate as illustrated ensuring that
the two tabs in sleeve A engage the tracks in hole C. Use care so as not to
scratch the painted surface of the peak while rotating the pressure plate.
Once the pressure plate is rotated into proper position, sleeve B will fall
into place within hole D.
Repeat for the other side.
Place the shield / base plate assembly in the helmet so that the two screw
holes line up and the latch pin on the left side of the helmet is in the latch
hole of the shield. Then, place the peak / pressure plate over the shield
so that the two screw holes line up. Install the two screws through each
pressure plate into the helmet and tighten with flat blade screwdriver or
coin. Do not over tighten.
Work the shield up and down to check the operation.
TO REMOVE/REPLACE CHEEKPADS/ EARCUPS
When first servicing the cheekpads, it is suggested that you do only one at
a time so that the other can be used as a reinstallation guide.
X-TEND / X-TEND CT / X-TEND RAM / X-TEND RAM CT / XC / XC-RAM / CT-Z
To remove the cheekpads, first undo chinstrap. Pull the pad toward the
front of the helmet, then inward to release and slide it off the strap.
To take off the fabric covering for washing, peel the covering off over the
front edge of the cheekpad assembly until all the fabric is on the face side
surface. Then draw the rectangular collar through the opening by rotating
the collar vertically and putting into the opening.
To wash fabric coverings, put them into lukewarm water with small
amount of laundry soap or your own shampoo and wash gently by hand.
Rinse well with fresh water and wipe off with a soft cloth. Dry them in the
shade at ambient temperature.
HOLE “D”
HOLE “C”
SLEEVE “A”
SLEEVE “B”
LATCH PIN
