20
IMPLEMENT SETTINGS
11.1
Boom
1
Indicate the number of boom sections.
2
Indicate the distance between spraying points (nozzle holders).
3
Indicate the number of spraying points (nozzle holders) installed on each boom section.
3a
Repeat the setup for each section (
).
3b
It allows to enable/disable specific boom sections. Repeat the setup for each section, by disabling the disconnected outputs.
4
The displayed number of valves / Seletron that can be managed depends on the type of VT connected to the system.
The VT could be able to manage just a limited number of sections, therefore, should it not be possible to manage all nozzle doors individually, the VT
will group them so as to fully exploit the number of permitted sections.
5
Displays the type of installed end nozzles (Basic settings,
chap
1
2
*
3
4
5
Fig. 35
3a
3b
Fig. 36
Depending on the selected settings, the total number of spraying points as well as the value of the boom width, displayed in
,
will change.
*
SELETRON SYSTEM:
The operator may choose the way in
which the boom is subdivided into
different sections: this is done in order to
act on the corresponding control when
closing sections manually.
With automatic management, instead, the
computer acts on each single Seletron
separately.
SECTION
VALVE
1
SECTION
VALVE
2
TOT
BOOM WIDTH
Fig. 37
Quits without confirming the
changes
Saves the changes
Delete
Quit
Confirm
Goes back to previous menu,
or scrolls the pages of a menu
(previous page)
Scrolls the pages of a menu
(next page)
Goes back to Main screen
Saves the changes to current
page
