Models for the production of hot water
21A
We went on to detail all the chrono-temperature symbols, before making programming in menu 1.
C :
Enables the chrono. It will turn on and off, according to the settings made in the
menus 1- 2 and 1-3.
T :
Enables the room temperature probe. Modulates the ambient temperature according to
schedules made in menus 1- 2 and 1-3.
S :
Enables the differential temperature that allows the stove to be turned off if the boiler temperature
exceeds in 7 degrees of the set value.
E :
Enables the external probe allowing the stove to be turned on if the value of the external temperature
is lower than the value programmed in menu 1 - 3 (on week). It is advisable that the installation of the
external temperature probe, be carried out by the technical service.
* :
Indicates that the accelerator pump is activated.
<56ºC> 58ºC :
The temperature between angular brackets corresponds to the programmed value
(setpoint temperature). The temperature on the right corresponds to the temperature of the
water
accumulator.
In this same screen using increment or decrement keys, we can modify the setpoint
temperature temporarily. Remember that at the start of each ignition, the setpoint temperature could have
changed according to the settings made in any of the two calendars (chronothermostat).
P=1.2Bar :
Indicates the water pressure.
T=66ºC :
Indicates the temperature of the water inside the boiler.
21B - We enter water temperature programming.
Limits the maximum water temperature.
21C - we choose temperature.
21D -We increase temperature.
21E - We exit water temperature adjustment.
21F - Adjusted temperature.
7
