Aquion ProFlow, Technical Manual

Page: 13 / 52

ELECTRONIC CONTROL PANEL
Page 13
SIMPLEX ECO :
1. Press the scroll button and hold it for 5 sec until the
display shows:
2.
Within 10 sec, press the up button; the display will
show:

Press the up or down button to set the hardness
unit . Make sure to also adjust/convert the exchange
capacity!
3.
Press the scroll button again; the display will show:

Press the up or down button to set the
exchange capacity per litre of resin .
4.
Press the scroll button again; the display will show:

Press the up or down button to set the volume
of resin .
5.
Press the scroll button again; the display will show:

Press the up or down button to set the number
of days between regenerations .
6.
Press the scroll button again; the display will show:
 Press the up or down button to set the length
of the regeneration cycle .

Press the scroll button again to advance to the next
regeneration cycle.
Cycle 1 Backwash
Cycle 2 Brine draw/slow rinse
Cycle 3 Fast rinse/refill
7.
Press the scroll button again; the display will show:
 Press the up or down button to set the type of
water meter sensor .
8. Press the scroll button again; the display will show:

Press the up or down button to set the
regeneration mode :

Dlyd/Immd : when the remaining capacity equals
the reserve capacity, a delayed regeneration at
the programmed time of regeneration is started;
however when the remaining capacity equals 0
before the programmed time of regeneration is
reached, an
immediate regeneration is started.
 Immediate : when the remaining capacity equals
0, an immediate regeneration is started.

Delayed : when the remaining capacity equals the
reserve capacity, a delayed regeneration at the
programmed time of regeneration is started.
9.
Press the scroll button again; the display will show
(only when the regeneration mode is set to ‘Delayed’ or
‘Dlyd/Immd’):

Press the up or down button to set the time of
regeneration .
10. Press the scroll button again; the display will show
(only when the regeneration mode is set to ‘Dlyd’ or
‘Dlyd/Immd’):

Press the up or down button to set the reserve
capacity :

Variable : the reserve capacity is calculated
automatically, based on the registered daily water
usage.

Fxd : press the scroll button again and press the
up or down button to set the reserve
capacity to a fixed amount .
11.
Press the scroll button again; the display will show:

Press the up or down button to save the
program into the NOVRAM® and exit the
programming level.
Cycle 1: XX min
System Check
Regen @ 2:00
Exit
HardUnit: °f
Resin: XXX liters
ExCap: 5.5 °f M3/L
Override: 7 days
MTR: SNAP SENSOR
Regen:Dlyd/Immd
2:00
Rsrv Variable