AquaVac TigerShark, Owner'S Manual

Page: 8 / 20

TIGERSHARK QC OPERATING INSTRUCTIONS
1. For installation, setup and general operation information refer to the General
Operating Instructions located on page 6. For selection of the desired cleaning cycle
follow steps 2 and 3 below.
2. When the TigerShark model is initially switched on, the Quick Clean cycle will
automatically be selected. This is indicated by the light on the cycle selection switch
located on the power supply. The TigerShark QC pool cleaner will automatically
shut-off in 60 minutes.
3. To select the Full Clean cycle, depress the FULL CLEAN button at any time during
the Quick Clean cycle. The Full Clean cycle will be indicated by the light on the
cycle selection switch. In the Full Clean cycle the unit will automatically shut-off
in 3 hours.
if the Quick clean cycle is complete, the on / off power switch must be turned off
and back on, and then the full cycle can be chosen during the Quick clean cycle.
TIGERSHARK PLUS ANd TIGERSHARK 2 PLUS
OPERATING INSTRUCTIONS
1. For installation, setup, and general operation information refer to the General
Operating Instructions located on page 6.
2. For the best operation of the remote control feature always place the Power Supply in
an area in clear sight and within 75 feet of the Remote Control. The Remote Control
can be operated at any time without disrupting the cleaning cycle.
3. To turn the cleaner while in operation depress and hold the button next to the
desired turning function indicated in the front of the hand held remote control. When
the button is released the turning function will stop and the TigerShark Plus will
resume its programed operation.
8