7 - 26
IsACQ455C-0 (ENG) Rev. 261108-0
Via dell’Industria, 20 - 42025 Cavriago (RE) Italy Tel.: +39 0522 494403
Fax: +39 0522 494410 http:\\www.aquatronica.com E-mail: [email protected]
Proceed as follows to connect the Koralia Wave Module to the Aquarium Controller
System correctly:
1)
Connect the power supply lead (optional) to the dedicated socket at the back of the
device.
2)
Connect the Koralia Wave Module to the Aquarium Controller System using the BUS
cable supplied in the package.
3)
Fit the special ferrite accessory used to prevent electro-magnetic disturbance on
the cables of the Koralia pumps, as illustrated below.
4)
Connect the Koralia pumps to be piloted to the dedicated sockets.
5)
Switch the Koralia Wave Module on, by switching the ON/OFF switch at the back of
the device from position “0” (Off) to position “I” (On).
INITIALISATION PROCEDURE
Once the Koralia Wave Module has been switched on, the pumps connected to it start-
up quickly one after the other (P1..P2..P3 and P4) reaching their maximum power for
5 seconds each one, after which the corresponding rpm indicator LEDs of the pumps
switch on.
First-time connection of the Koralia Wave Module
PHASE 1:
Open the
ferrite accessory us-
ing the special key
supplied.
PHASE 2:
Wind the
cables of the Koralia
pumps twice around
the ferrite accesso-
ry, positioning it at a
maximum distance of
20 cm from the Koralia
Wave Module.
