INITIAL SET-UP
Your RO Daddy utilizes a metal frame to securely support the
membrane and three large (blue) canisters securely. The frame
can be secured to a wall so that it cannot move easily but it
should NOT be suspended by the frame. The weight of the unit
without water is 75 pounds, when water is added it will exceed
110 pounds, and the frame cannot support the weight if suspended.
The RO Daddy is shipped with the membrane already installed.
This was done to reduce the initial setup time for the unit.
Three filter cartridges are included with the RO Daddy. Each
cartridge is wrapped with a clear protective film that needs to be
removed prior to use. Use the canister wrench to remove the
blue canisters and access the cartridges.
CANISTERS AND CARTRIDGES
After the protective film has been removed from the cartridges
they should be installed in the following locations.
RIGHT - Micron cartridge
should be located in the right side
canister; this cartridge is the all-white fiber cartridge.
MIDDLE - GAC cartridge
should be located in the center
canister; this cartridge is made with a solid plastic housing
with a top and bottom cap.
NOTE:
This cartridge needs to be installed in the proper
manner; it will have a sticker on the film indicating which
end is up.
LEFT - Solid carbon block
should be located in the left
canister; it has webbing around it and has a solid feel.
The solid carbon block does not have any specific
orientation in the canister.
When replacing the canisters with the cartridges, make sure the
O-rings are located around the top of each canister. The O-rings
are shipped with a sealing lubricant, but additional can be
applied. The canisters should only require hand tightening but if
during operation you find small leaks, the wrench can be used.
w w w . a q u a t i c l i f e . c o m
RO Daddy
™
Instruction Guide
NOTE:
If the canister has a strong leak,
STOP the water flow
and check the
O-ring to make sure it is in place.
If the O-ring slipped off the lip of the
canister, re-install the O-ring.
