13 |
A GH 5 I N S T R UC T I O N M A N UA L
STEP 6:
Install the camera on the saddle by aligning the threaded hole under the camera
and screwing the bottom screw with either a flat screwdriver or a coin.
NOTE:
If you are using an optical flash triggering, install your flash trigger on your
camera by following the procedure outlined in the
Flash triggering
section
STEP 7:
Slide the saddle and camera inside the housing using the two guiding pins. Push it
all the way through until you feel the saddle lock engaging. Perform a check by
pulling on the saddle to ensure it is firmly attached to the housing.
NOTE:
If you are inserting your camera with a lens attached, make sure to first pull out
the zoom-focus knob to avoid interference between the gear ring and the
housing. To lock the knob out during insertion, rotate it in either way while
pulled until it sits on the locking pins.
