19 |
A GH 5 I N S T R UC T I O N M A N UA L
Accessories
Surveyor sensor
Your AGH5 housing comes standard with the Surveyor moisture alarm. This sensor device has
two distinct purposes, a moisture detection circuitry and an ambient pressure sensor circuitry.
NOTE:
Once a battery is installed, the moisture detector function of the Surveyor alarm
will remain on standby and does not need to be activated. If not being used for a
prolonged period of time, it is recommended to remove the battery from the
sensor circuit to avoid unnecessary drain.
To insert your CR 2032 battery:
STEP 1:
With the (+) side facing up, slip the battery under the plastic tab (B).
STEP 2:
Push the part of the battery that is sticking out into the holder (on A side).
To remove your CR 2032 battery:
STEP 1:
Push the plastic tab (B) away from the holder.
STEP 2:
Grab the battery by each side sticking out of the holder and pull it out.
WARNING:
If you are only using the moisture alarm function without the vacuum, it is
recommended to perform a quick test of the circuit before every dive. To do so,
simply moisten the tip of your finger and establish contact between the board
probes (#7). If it fails to activate the alarm, check that the battery is correctly
inserted and replace it with a fresh one if required.
1
Sensor circuit
2
Battery holder
3
Vacuum power switch
4
CR 2032 3V battery
5
External LED point
6
Integrated warning LED
7
Probe wire harness
A
B
