Aquatic Fitness System - Owner’s Manual
7
11. If there is no jet action, then the water level is
too low or there is air trapped in the plumbing.
To eliminate the trapped air, turn the pumps on
and off several times to force the trapped air
through the pumps. If there is still no jet action
turn off the pumps and loosen the top pump
unions (see illustration earlier) slightly to let any
trapped air escape. Re-tighten the pump unions
and turn the pumps on again. Turn the pumps
on and off several times until jets function
properly.
The Display Window does not allow you to set the temperature above 104
q
F
(
#
40
q
C). However, if the water temperature exceeds 104
q
F (
#
40
q
C), the display will
show the actual temperature.
Never get in water if the temperature exceeds 104
q
F (
#
40
q
C).
12. After the jets are functioning properly, replace the filters. To adjust the temperature you
want your swim spa to be, use the up and down key until you reach the desired
temperature. Press the “accept” button to save this temperature in memory.
13. While heating your AFS, inspect the pump unions and plumbing fittings for leaks. When
you have finished the inspection, you can reinstall the equipment compartment panel.
14. After completing the above steps, see the Water Care Guide (provided separately) to
ensure proper water chemistry.
15. Place the thermal cover on your Aquatic Fitness System to conserve energy and keep it
ready for use. Remember to always lock your AFS cover when not in use.
Summary of Contents for AquaFit 16
Page 1: ...i...
