Easy to install
1
Unpack and unwrap contents. Turn off and
disconnect the cold water supply.
6
Select a space under your sink for
the filter unit that is at least 12" (30
cm) from the bottom of your cabinet to
allow easy access to the water and for filter
replacements. Use the mounting holes located
at the back of the unit to mark the wall screw
placements. Hole distance: 98mm
8
Attach each sump to the bottom of the unit
housing. Align connection points, push the sump up
and turn to the right. Ensure that the sump is locked in
and in the correct order as shown.
10
Turn the cold water on. Check for
leaks and proper installation: place a
towel under the filter unit and check for leaks.
Allow water to run for 20 minutes to flush
carbon fines. Note: Never use oils to lubricate
the O-rings; O-rings come pre-lubricated.
3
Attach 3⁄
8
" white tube to the brass tee: slide the compression nut onto
the white tubing (with threads of the nut facing the end of the white
tube). Next, slide the plastic sleeve onto the white tube. Place brass insert
into the opening of white tube. Push the tip of the white tubing into the
opening of the brass tee. While holding the white tube in place inside the brass
tee, tighten the compression nut to compress the plastic sleeve and create a
seal. NOTE: Use a wrench to ensure complete seal. Avoid over tightening.
9
Connect supply lines: insert 3⁄
8
" tubing
from the tee fitting into the inlet side and
insert 1⁄
4
" tubing from the faucet into the outlet
side. Use diagram on the right to mark tubing
depth to ensure they get inserted completely.
It is VERY IMPORTANT to insert tubing
completely so leaking does not occur.
4
Faucet
Installation:
Install as shown.
Tighten nut to secure
faucet to sink.
7
Use a 7⁄32" (6mm) drill bit to drill holes.
Carefully tap the plastic anchors into the
drilled hole with a hammer. Mount unit to
the wall with the screws. Pull the protective
plastic strip from the battery compartment.
The red LED should flash and beep five (5) times
to indicate that the battery is installed correctly.
2
Attach threaded ends of supplied brass tee
to the cold water supply line and shut-off
valve; tighten using an adjustable wrench.
5
Faucet Connection: connect the ¼" outlet tubing to the
base of the faucet by sliding the chrome nut onto the
tube followed by the white collar. Place the white insert into
the end of the tube. Press the tube against the faucet base
and slide the nut and collar up to the threads. Use wrench
to ensure seal is sufficiently tight.
Note: Avoid over tightening.
2
1
E
H
F
M
G
K
N
K
L
J
O
O
1
INCH
CM
2
3
4
5
6
7
8
25mm
.98”
1
2
3
Depth to insert tubing (actual size)
A
