ATTENTION! The water obtained during washing is not intended for drinking!
Fig. 3
Fig. 4
Step 2
Preparing the water purifier for operation
• Remove the lid from the water purifier by turning the three latches
counter-clockwise 90 ° (Figure 5).
• Remove the heat shrink foil from the K5 and K7 modules.
• Moisten the O-rings on the plugs of the modules under the running water.
• Install the filter modules K5 and K7 on the collectors according to Fig. 2.
Washing of the softener unit
• Set the input tap to the "Open".
• Open the water tap and wait for water to flow from it. First, air will leave
the water purifier, which may give some noise.
• Wait till all air has left the tube with the corner and the water flows (service
mode for air removal, see fig. 3) and close the input tap.
• Gently remove the service plug, remove the corner, install the tube in
place of the service plug and put the clip (operating mode, see Fig. 4).
• Open the inlet valve again and continue the rinsing procedure.
• Let the water pass through the water purifier, until the air stops leaving
the drainpipe and water flows.
• Close the input tap.
• Again let the water pass through the water purifier in an amount from 50
to 100 litres.
• Close the tap
Fig. 5
Stop button
Fig. 6
The first week of operation, check the water purifier every day for leaks.
During the first week of operation of the water purifier, there may be noise associated with the release of air from the internal
cavities. After a while the noise will disappear. It is not a malfunction.
Tube with corner
Service plug
Inlet
Outlet
1
2
3
1
2
3
4 –
The key for the JG tube
5
