Aquametro Oil & Marine Viscosity VC312, Installation And Operation Manual

Page: 20 / 32

20 VCS – Viscosity Controller
7 Decommissioning, dismantling and disposal
CAUTION
The surfaces of the device/system and the medium may be hot.
Risk of burns!
Carry out work only on cooled devices/systems.
Work may only be performed by authorized specialists in accordance with
the applicable regulations.
Use appropriate protective equipment.
WARNING
The device/system may be under pressure.
Risk of severe injury!
Carry out work only on non-pressurized devices/systems.
When working on the device/system watch out for leaking medium.
Work may only be performed by authorized specialists in accordance with
the applicable regulations.
Use appropriate protective equipment, particularly safety goggles
7.1 Decommissioning
Disconnect all sources of energy.
Remove the devices from the system.
Pay particular attention to the disposal instructions in section 7.4.
7.2 Dismantling
Not required.
7.3 Return of materials
Never send a device/system back if you are not absolutely certain that all traces of hazardous substances have
been removed, e.g. substances which have penetrated crevices or diffused through plastic.
Costs incurred for waste disposal and injury (burns, etc.) due to inadequate declaration and/or cleaning will be
charged to the delivering company or the operator.
For a device that is sent back to Aquametro Oil & Marine for repair or calibration the following point are an
absolute must:
Always quote type and serial number when contacting an Aquametro Oil & Marine office or an
Aquametro representative.
Always enclose a duly completed "Declaration of decontamination” form (FO0451e).
Only in special cases (e.g. for the reconstruction of causes of errors) and only with the prior consent of
the Aquametro Oil & Marine, equipment must be returned in the impurified state. In this case also the
contact person at Aquametro Oil & Marine, which has granted the approval to return a crude device
must be stated.