Axis Digital concealed
installation instuctions
page 12
Set the fixing bracket into
position and mark the fixing
points. Remove the bracket
and drill and prepare
suitable fixings. Refit the
fixing bracket and secure it
through the ceiling and into
the noggin using the screws
provided if suitable.
5
Refit the cover plate onto
the fixed head arm and feed
it through the fixing bracket
to the correct depth.
Tighten the nut using a
32mm spanner if necessary
to facilitate.
6
Cut off the excess pipe allowing for a suitable working length
to allow for the required connection. If a push fit connector
is to be used then the pipe must be abraded to remove all
chrome plating.
7
Connect the pipe work from the valve to the pipe end for the
fixed head using a suitable coupling. Fully tighten the nut
on the ceiling mounting bracket using a 32mm spanner if
necessary to facilitate.
8
Run the shower for a few seconds to clear any debris and
to check for any leaks.
!
Carefully slide the cover
plate back over the fixed
head arm and into position
against the ceiling.
9
Secure the shower head
tightly to the fixed head
arm using a 28mm spanner
to facilitate tightening.
Check the installation for
leaks then fit the badge to
the front of the spray plate.
10
