5
How to install your AquaJoy SAVER Bathlift
The Aquajoy Saver can be easily installed in
two
sections:
Seat section including actuator
(A)
Base section
(B)
Seat Section
(A)
Base Section
(B)
How to install your Aquajoy Saver Bathlift
Please ensure your bath is clean and dry before installing your bathlift.
Remove transit clip (
Fig 1
above)
Once the bathlift is removed from the box / packaging, remove / lift the seat section from the base
section.
Moisten the suction cups and place the base section on the flat part towards the back of your bath.
Push down on the base unit to ensure the suction cups have a good hold (
Fig 2
).
WARNING:
Very rarely, the suction cups may not adhere properly on textured areas of a bath. If this
occurs, extra middle suction cups should be added – ask your supplier for further details.
Fold the side flaps onto the seat and slide the seat section down onto the base section in the bath.
ALWAYS ENSURE THE BLUE ACTUATOR LATCH, BLUE BRACKET ARE ALWAYS FULLY ENGAGED /
PRESSED IN PLACE / PIN IN PLACE BEFORE USE
.
Please use the Side Flap Diverters provided if your bath has handles on. They are designed to prevent
the side flaps from being caught under any handles. Simply push the Diverters over the handles on your
bath (
Fig 3
).
Plug your charged hand control into the actuator connector. The bathlift is now ready for use.
Fig 1
Fig 2
Fig 3
