ASSEMBLY
10
aquaglide.com | © 2017 Aquaglide
1) Locate a flat, dry area with access to electrical outlet or extension cord. IM
-
PORTANT: Because of the size and weight of the Rockit™ Jr. , careful thought
must be given to the setup area. Ideally, the Rockit™ tube should be carried into
position while inside it’s protective storage bag. The best setup position will also
make launching easy. Therefore, locate the Rockit™ near the water’s edge. NOTE:
Dragging or sliding the Rockit™ over ground either before or after inflation can
cause damage.
2) Once in the setup/ launch position, unfold the Rockit™ Jr. completely and locate
the Main Valve. The Main Valve is located on the lower half of the product, near
Warning Labels and in white material. See diagram for details.
3) Using a high output pump, place the inflation hose with proper adaptor into the
Main Valve to inflate the Main section of the Rockit™ Jr. Inflate to 0.75 psi (0,052
bar). Check for proper air pressure using a manometer. After inflation, replace Main
Valve cover. Inflation times can vary by inflator, but the main section should be firm
and tight when completely inflated. DO NOT OVER-FILL. Excessively high pressure
can cause damage to the product and may void the warranty. Carefully monitor air
pressure in the product especially during hot weather.
WARNING: Do not use an air compressor to inflate tube. Air compressors are
de-
signed for high pressure inflation and can cause tube to burst if over-inflated.
WARNING: Do not use the Rockit™ Jr. without adequate air pressure - 0.75 p.s.i.
(0,052 bar) minimum.
4) Next locate the Perimeter Tube Valve found above the Main Valve, and on the
blue material of the perimeter tube. Follow the instructions and warnings found
in Step #3 to properly inflate the perimeter section. Inflate to 2.25 psi (0,155 bar).
Check for proper air pressure using a manometer.
5) Next inflate the 4 Saddle Chambers found just above the Perimeter Tube.
Follow the instructions and warnings found in Step #3 to properly inflate the Saddle
Chambers. Inflate to 1.9 psi (0,131 bar). Check for proper air pressure using a
manometer.
6) To launch the product, make sure to have at least 4 people evenly spaced
around the product to help carry it. NEVER DRAG THE PRODUCT! YOU MUST
LIFT AND SET TO AVOID ANY ACCIDENTAL TEARING AND/OR ABRASION.
