43
W
W
a
a
r
r
r
r
a
a
n
n
t
t
y
y
I
I
n
n
f
f
o
o
r
r
m
m
a
a
t
t
i
i
o
o
n
n
The following installation and operating conditions are considered hazardous or damaging
to the equipment and can compromise the ability of the Aquafine
®
unit to perform as
intended.
Any of the following conditions will void the equipment warranty:
1. Failure to connect proper electrical service to unit.
2. Failure to properly ground the unit.
3. Failure to eliminate excessive vibration, piping, movement, or “water
hammer”.
4. Failure to exercise caution in the handling of the sensitive and delicate
components (such as lamps, quartz sleeves, electronic boards, etc.)
during installation and/or maintenance procedures.
5. Failure to avoid excessive stops and starts. Not more than three (3)
“ON/OFF” cycles per 24 hours of operation.
6. Operation of visibly damaged equipment.
7. Failure to avoid undue overhead piping stress, which can result in
structural damage to the UV unit. Limit the load to 25 lbs, for 2” & 3”, 50
lbs, for 4” and 75 lbs, for 6” or above. Torsion loads or side loading of the
risers should be eliminated.
8. Use of components other than those provided or authorized by Aquafine
®
.
9. Failure to correct overhead piping connection leaks or compression nut
seal leaks which result in damage to the electrical components.
10. Allowing operating water temperature to exceed 120°F.
NOTE:
To maintain your UV unit’s warranty, please complete and return the Warranty
registration Card located in the back pocket of this manual.
Summary of Contents for optima hx series
Page 44: ...44 ...
