Aquafilter Clear Choice, Installation Manual

Page: 8 / 36

12. Connecting the EXCITO-WAVE and EXCITO-OSSMO systems to the water supply source
Turn the system around and screw off two screws with the
application of the Phillips screwdriver. Take off the upper housing.
Take off the IN and OUT system port securing plugs.
WARNING! Prior the plugs are taken out make sure to
remove the securing safety clips.
The tubing which goes out of the SEWBV1414 valve is to be led
through the upper housing of the system, next connect it to the
system inlet [IN].
The connecting section is to be secured with
the application of the safety clip.
4
Lead the tubing through the upper cover of the system, next
connect the tubing to the port
[OUT] (within the later installation
phase the tubing will be connected with the faucet. The
connecting section is to be secured with a safety clip).
Assemble the upper cover of the system and screw it on.
7
13. Installation of drainage - EXCITO-OSSMO
WARNING! Remember to take off the quick connector protection safety clip prior the process of taking out of the tubing or the blinding
element, next symmetrically press its flange. WARNING! Following the successful installation of the tubing within the quick connector
to secure the whole connection with the application of a safety clip.
Use a 'marker' to label the desired location of drilling upon the
outlet pipe.
WARNING! The choice of the location of drilling is
to be executed in such manner so as not to make difficult the
later access to the executed connecting section.
1
2
Use impact drill device and drill of the diameter amounting to
5mm to drill an opening within the outlet pipe within the prior
determined location.
WARNING! Devote particular attention to
the fact that the axis of the executed opening was to be
perpendicular to the axis of the pipe. Only one wall of the
pipe is to be subjected to drilling.
7