Aqua DGTEC CD, Instruction And Maintenance Manual

Page: 5 / 36

ADSP7000634 rev. 1.3 23/09/2020 5/36
1.3 TECHNICAL FEATURES
1.3.1 ELECTRICAL FEATURES
For the power supply value we recommend reading the label on the pump!
1.3.2 PERFORMANCE

Maximum height of the suction tube: 1.5 m

Flow rate and back-pressure: refer to Table 1, read the label on the pump to identify the corresponding
model.
Codes Power supply
Motor
Type
Flow
rate (l/h)
Backpressure
(bar)
Peristaltic
Tube
PT100
ADD400601C000000
(not available)
24 VAC/VDC 24 VDC 6 1 Santoprene
X
ADD4006010000000 230 VAC 24 VDC 6 1 Santoprene
X
ADD401000C000000
(not available)
24 VAC/VDC 24 VDC 10 0 Santoprene
X
ADD4010000000000
230 VAC 24 VDC 10 1 Santoprene
X
Tab. 1
The pump codes that may be ordered are found in the table. The manual also proposes pumps with unavailable
characteristics in the 4 models in the table (conductivity probe with PT100 sensor to read the temperature and 24
VDC output to activate the solenoid valve to dose solid detergent).

Operating ambient temperature: 0 ÷ 45°C

Transport and Packaging Temperature: -10 ÷ 50°C

Protection rating: IP65
2.0 INSTALLATION
2.1 GENERAL RULES
Pump installation must be carried out as follows:

In vertical position with an uncertainty not greater than +/-15°.

Away from sources of heat in dry locations, at a maximum temperature of 40°C and a minimum of 0°C.

In a ventilated environment and easily accessible to an operator for periodic maintenance.

Above the level of the liquid that needs to be dosed, at a height of 1.5 metres maximum.

Do not install the pump above the tank when using liquids that emit fumes, unless it is sealed shut.
2.2 INSTALLATION KIT
When you purchase the pump, it includes everything required for correct installation, specifically:

Bracket;

Dowels and screws;

Level probe ( optional );

Foot strainer (see Fig. 1- a );

PVC suction and delivery tubes (4 m.);

Conductivity Probe and Electrodes;

Tank inlet fitting (see Fig. 1- b );