14
AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO, TEMECULA, CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
1. COVER REMOVAL:
Remove the cover from the transformer box to allow access to screw holes located on the
back panel of the box. The cover slides down.
2. MOUNTING:
Mount the transformer vertically on to a wall or other vertical firm surface a minimum of 4' away from
dwelling. Make sure the transformer is close enough to attach to the UV unit.
ELECTRICAL INSTALLATION
4. DISCONNECT THE DAVIS CONNECTOR:
Unscrew the Davis connec-
tor located just above the transformer cap. This will allow the transformer
cap to turn without kinking the wire.
3. CONNECT THE LAMP(S):
Plug the lamp(s) into the clip connector(s)
located at the end of the individual harness(es). For 100 watt lamps connect
the red lamp wire to the black transformer wire and the black lamp wire to
the white transformer wire. For 200 watt lamps connect the red lamp wire to
the black transformer wire and the clear lamp wire to the white transformer
wire. Make sure the lamp(s) is plugged in all the way and flush with the clip
connector(s). Insert the lamp into the quartz sleeve.
NOTE:
Prevent finger marks on the lamp. If you touch the lamp use dena-
tured alcohol and a soft cloth to clean the lamp.
NOTE:
Lamps and quartz sleeves should be handled with care. Lamps and
quartz sleeves are not warranted against breakage and damage.
Be careful when installing the lamp. If the lamp is not plugged in all the way this may cause damage to the unit
and is not covered under warranty, nor is any other damage caused by improper installation.
In a vertical installation, do not drop the lamp into the sterilizer or it will break the lamp and or the quartz sleeve.
In a horizontal (or vertical) installation, do not install the lamp at an angle (even a slight angle); this may cause a “U”
shaped crack at the end of the quartz sleeve, or possible breakage of the lamp. If this should happen, do not proceed
with the installation. Purchase a new quartz sleeve or lamp from your dealer and refer to the proper installation instruc-
tions.
Do not force the lamp into the quartz sleeve; any force would be an indication of an improper installation.
(PLEASE SEE PAGE 20 FOR ILLUSTRATIONS).
Summary of Contents for SL 100 Watt
Page 28: ......
