Aqua Lung Rapid Diver, User Manual

Page: 23 / 32

23
POST-DIVE INSPECTION
1. Avoid prolonged exposure to direct sunlight and extreme heat. Nylon fabric
can quickly fade when exposed to the sun’s ultraviolet rays and extreme heat
may damage the welded bladder seams.
2. Avoid repeated or prolonged use in heavily chlorinated water, which can cause
the BC fabric to discolor and decay prematurely.
3. Do not allow the BC to chafe against any sharp objects or rough surfaces
that could abrade or puncture the bladder. Do not set or drop heavy objects
such as block weights on the BC.
4. Avoid any contact with oil, gasoline, aerosols or chemical solvents.
5. To preserve the life of the bladder, rinse it inside and out with fresh water after
every day of use, using the following procedure:
a) Pressurize the power inflator with medium pressure (MP) air via the
MP hose.
b) Using a garden hose, direct water through the oral inflator mouthpiece
to flush the interior of the bladder and then thoroughly rinse the exterior
of the BC.
c) Completely drain the bladder of water, either through the oral inflator or
through the OPRV / dump valve.
d) After rinsing, inflate the BC and allow it to dry inside and out.
CAUTION: Before rinsing, ensure that the inflator is pressurized with air. This
will prevent debris and contaminants from entering the valve mechanism if the
inflator button is accidentally depressed.
Storage
Store the BC partially inflated, away from direct sunlight and in a clean, dry
area. Do not store the BC in an enclosed space, such as a car trunk, where
temperatures may fall below 0ºF (-18ºC) or rise above 120ºF (49ºC).
NOTE: See product specific manual for post-dive inspection instructions of equipment
not covered in this manual (regulator, gauges, cylinder).
Transport
To avoid damage, store the Rapid Diver appropriately in the carry case provided
with this product. An optional hard case (sold separately) is available for added
protection in more rugged environments.