TYPE 3 - hung/J or V-bead line
With a V-Bead liner you will not se the plastic coping strips that are packed in
the parts carton of your pool. You can discard those pieces, if they are included,
as they only apply to pools with overlap liners.
The top of the wall of the liner has what is called a “V-Bead” welded onto it.
Simply open up the bead with your fingers and hang it directly on top of the pool
wall. (image 23) When this is done properly, the only portion on the outside of
the pool wall is approximately 1” of the V-Bead. No printed liner material is actu-
ally going over the top of the wall to the outside of the wall.
Make sure the bead is on evenly around the entire pool, and that the liner
is hanging straight down from the top of the wall. The liner should not have
creases in it because it is twisting around the pool. If the liner is twisting, it is
because it is not sitting properly in the pool. Make necessary adjustments before
proceeding.
IMPORTANT NOTE:
Some liners may fit very tightly, it is better to
install uprights, top plate and rail before going
onto next step.
IMPORTANT NOTE:
Do not trim off the excess liner. (if the liner
ever needs to be removed, trimming the liner
will make re-installation very difficult.) Instead,
roll up any excess liner and tape it in place
near the top of the wall.
16
23
05
SECTION
GENERAL INSTRUCTIONS - ROUND POOLS
INSTALLING
THE LINER
Summary of Contents for Contempra Round
Page 1: ...GENERAL INSTRUCTIONS for regular installation...
Page 24: ......
