TYPE 1 - overlap
Starting at the liner wall seam, hang the liner over the wall making sure that
the seam is straight up and down, perpendicular to the floor. (remove stabilizers
gradually as you fold the liner over the top of the wall.) This will assure you that
the liner begins going over the wall straight.
As you put the liner over the wall you can secure it by using the plastic coping
strips to keep it in place. If you end up with excess material, continue around the
pool, pulling excess liner evenly, and distribute over the wall until the excess is
gone.
Fasten liner to the top of the wall with plastic coping. Let liner hang slack for
now. Do not pull liner tight. (image 19)
Turn the vacuum cleaner on and push the liner outward with your feet to iron
out any wrinkles. Once finished, turn off vacuum cleaner.
Start filling the pool with water. As the pool fills, work out all the wrinkles and
smooth the liner to the wall. Remove the plastic coping around the top edge of
the wall one piece at a time and adjust the liner. Keep smoothing out the wrin-
kles.
After all the wrinkles in the liner are removed, trim any extra length of plastic
coping so there is no overlap. (image 20)
Roll up any excess liner hanging below the plastic coping and tape it in place
near the top of the pool wall. Do not trim off the excess liner. (image 21)
05
SECTION
GENERAL INSTRUCTIONS - ROUND POOLS
INSTALLING
THE LINER
IMPORTANT NOTE:
Some liners may fit very tightly, it is better to
install uprights, top plate and rail before going
onto next step.
IMPORTANT NOTE:
Do not trim off the excess liner. (if the liner
ever needs to be removed, trimming the liner
will make re-installation very difficult.) Instead,
roll up any excess liner and tape it in place
near the top of the wall.
19
20
21
14
Summary of Contents for Contempra Round
Page 1: ...GENERAL INSTRUCTIONS for regular installation...
Page 24: ......
