Copyright © 2016 Aqua Creek Products All Rights Reserved
Revised 12/13/16
Unpacking And Assembly
LOWER MAST
UPPER MAST
1/4"-20 X 1 1/2"
BUTTON HEAD
W/ SLEEVE SHRINK
1/4" FLAT
WASHER (2)
1/4" FLAT
WASHER (2)
1/4" X 1-3/4"
HEX BOLT
1/4" NYLOCK
NUT
1/4" NYLOCK
NUT
BATTERY CABLE
CONNECT
TUBE
FLIP UP
BATTERY CABLE
DO NOT PINCH!
CHARGE CONNECTOR
LOWER MAST
UPPER MAST
SOLAR-PANEL
ASSEMBLY
BATTERY CABLE
BATTERY CABLE
CONNECT TUBE
CHARGE CONNECTOR
A
FLIP-UP
SOLAR PANEL
ASSEMBLY
SOLAR CHARGE
CONTROLLER
MOUNTING POST
( 1/2"-13 THREAD)
To assemble the Solar Charger you will need two (2) 7/16” wrenches or sockets.
The 24V Solar-Charger comes fully wired, in two halves for shipping. To assemble the charger remove it
from the shipping box and connect the UPPER MAST to the LOWER MAST by fl ipping the UPPER MAST up
and sliding the CONNECT TUBE inside the UPPER MAST and aligning the holes as shown above. Pull the
BATTERY CABLE and the CHARGE CONNECTOR through the tube as you slide the TOP ASSEMBLY down.
DO NOT PINCH THE BATTERY CABLE! Install the supplied 1/4” x 1 1/2” hex bolt, the fl at washers and
Nylock-nut as shown. Tighten until snug.
Next, fl ip-up the SOLAR PANEL ASSEMBLY until it is fl at-horizontal, and install the 1/4” x 1 3/4” hex bolt
and fl at washer underneath as shown. Install the 2nd fl at washer and the Nylock nut on the opposite
side, and tighten until snug. The Solar Charger is now ready to install on your pool lift.
3
