MULTISWITCH
handle PWM signals before
before
before
before you activate this function. Failure to do so
Failure to do so
Failure to do so
Failure to do so
may result in the destruction of the connected devices!
may result in the destruction of the connected devices!
may result in the destruction of the connected devices!
may result in the destruction of the connected devices!
If the multiswitch™ is used as an aquabus-device on the aquaero, the
PWM function is always deactivated and the jumper setting is ignored.
Jumper open:
PWM activated
Jumper closed:
PWM deactivated
Jumper position 4: Button function
Jumper position 4: Button function
Jumper position 4: Button function
Jumper position 4: Button function
This jumper configures the functions of the buttons on the front of the
device (supprted only in devices with buttons).
When the jumper is set, the condition (on/off) of the corresponding
power output is switched. Additionally the outputs may be switched via
the PC-software if the multiswitch™ is connected via USB (not possible if
connected as an aquabus-device).
With an open jumper setting the buttons have no direct influence on the
outputs of the multiswitch™ and are only interpreted via the PC-software
when connected as an USB-device.
If the power outputs of the multiswitch™, when connected as an
aquabus-device to the aquaero, should be switched, the jumper must be
open!
Jumper open:
Interpret buttons only via the PC-software
Jumper closed:
Buttons switch power outputs directly
Jumper position 5: USB/aquabus
Jumper position 5: USB/aquabus
Jumper position 5: USB/aquabus
Jumper position 5: USB/aquabus
This jumper configures which interface of the multiswitch is active.
Jumper open:
USB enabled, aquabus disabled
Jumper closed:
aquabus enabled, USB disabled
- 10 -
Aqua Computer GmbH & Co. KG
© 2005-2012
Gelliehäuser Str. 1, 37130 Gleichen
