AQUADUCT
2. Insert the hose into the connector up to the limit
stop.
When inserting the hose a first limit stop will be felt
which has to be overcome with some effort. If you want
to be on the safer side you can mark the hose with a
felt pen up to where you have to insert it. Depending on
the connector it will be between 18 and 20 mm.
If the hose has to be detached please do the following:
1. Push down the black or blue plastic ring
on the connector. For this purpose you
can also use the separately available AC
Multi-Tool. Slip it over the hose with the
middle opening.
2. While pushing down pull the hose from
the connector.
It is important to remove the length of hose
which had been inserted into a connector
before connecting the hose again. It must
not be scratched to secure a perfect sealing of the connector.
Now a few remarks about our hose. The hose we use is made of poly-
urethane. It has an outer diameter of 8 mm and an inner diameter of 6
mm. It makes bending radiuses of less than 10 cm possible and is resist-
ant against many chemicals. A great advantage of the system is that it
seals the hose on the outside. This allows the use of the complete dia-
meter, unlike the use of hose barbs which are inserted into the hose and
therefore have to have a smaller inner diameter than the hose. With a
cross-section area of about 30 mm² the system allows a sufficient flow
even in larger lengths of hose.
© 2007
Aqua Computer GmbH & Co. KG
- 11 -
Gelliehäuser Str. 1, 37130 Gleichen
10
0
20
1
2
