Wet type dust collector
12
11 MAINTENANCE AND INSPECTION
The chart indicated below shows different inspections and the frequency at which they should be
performed.
Frequency of
inspections
Components
Procedures
Daily
Tank
Check that the water level is adequate and that
the fleet is functioning well.
Monthly
Tank
Check for mud build-up, clean if necessary.
Check to see if the water is very black and muddy.
If so, the dust collector should be cleaned.
Yearly
Dust collector
Inspect, clean and touch up paint if necessary.
Check the valves and the fleet.
Problem
Probable cause
Solution
Insufficient suction
of the dust collector
Water level too high
Adjust the water level, check the water supply system.
There is too much mud. Empty the tank, clean and fill it with new water.
There is dust coming
out at the exit of the
dust collector
Water level too low.
Adjust the water level, check the fleet system.
The supply solenoid
valve does not work.
Check if the solenoid valve is supplying water.
Repair or change it as needed.
There is water esca-
ping from the exit
Elimination panels are
improperly installed.
Check that the panels are incorrectly installed, check
that everything is properly fixed. Correct as needed.
There are leaks in the
inspection panels.
Check that there are no leaks. Correct as needed.
12 TROUBLESHOOTING
Summary of Contents for MAXIHYDRO MS
Page 8: ...Wet type dust collector 8...
Page 9: ...Wet type dust collector 9...
Page 10: ...Wet type dust collector 10...
Page 11: ...Wet type dust collector 11...
