Wet type dust collector
5
4 2 SET-UP AND START-UP PROCEDURES FOR WET TYPE DUST
COLLECTOR
4.1 Level the unit
Check to ensure that the unit is level in all directions.
4.2 Check all connections
Check that the gasket between the inlet duct and the transition interface is correctly positioned
between the flanges and that the flanges are tightly bolted.
Connect the inlet and outlet ducting to the unit. Check that the gaskets are correctly positioned
between the duct runs and the unit, and that all unions are tightly bolted.
MS TYPE – STYLE A
The MS Type Style A is a highly efficient dust collector with a low noise level. It can easily be
installed inside a plant or tool room, and heated or cooled air can be discharged back into the shop.
The MS Type Style A comes with a hand rake and sludge bin for sludge disposal.
Figure 2
AIR
INLET
MIST
ELIMINATOR
PLATES
SLUDGE RAKE-
OUT CHUTE
INLET
CONTROL PANEL
AUTOMATIC WATER
CONTROL SYSTEM
ACCESS DOOR
Summary of Contents for MAXIHYDRO MS
Page 8: ...Wet type dust collector 8...
Page 9: ...Wet type dust collector 9...
Page 10: ...Wet type dust collector 10...
Page 11: ...Wet type dust collector 11...
