APV PS 300 M1 D, Operating Instructions Manual

Page: 38 / 60

38
Procedure
This is how to set the minimum fill level:
Step Description
1 Loosen the nuts on the sensor.
2 Move the sensor on the assembly plate to the desired height and tighten the
nuts.
Setting the intensity
The intensity of the sensor can be adjusted using the potentiometer (small slotted
screw) on the rear side of the sensor to adapt it to the respective seed type. To check
the sensor and the setting, cover the front side of the sensor with your hand. The
sensor is functional and correctly set when the LED on the rear side of the sensor then
lights up.
5.11 Filling the spreading material tank
Purpose
The seed tank stores the seed to be spread.
Requirements
The following requirement must be fulfilled for this work step:
•
The implement is disconnected from the power source, see
Disconnecting the
seed drill from the power source
On page 41.
Required components, tools and materials
For this work step, the following components, tools and materials are required:

Seed
Overview
No. Designation
1 Seed tank cover
2 Seed tank
3 Flap fastener with lock