APV PS 300 M1 D, Operating Instructions Manual

Page: 24 / 60

24
Step Description Explanation/illustration
6 Connect the hoses to the dispersion
plates, see
Connecting the hoses
On
page 24 for more information.
4.4 Connecting the hoses
Purpose
The hoses convey the seed from the seed drill onto the field. Before initial operation,
the hoses have to be cut to the required length and installed on the dispersion plates
and the seed drill.
Requirements
The following requirement must be fulfilled for this work step:
•
None
Required components, tools and materials
For this work step, the following components, tools and materials are required:

Hose roll

Cutting tool

Torx screwdriver TX 30

Silicone spray
Procedure
This is how you connect the hoses to the seed drill:
Step Description Illustration
1 Using the cutting tool, cut off pieces from
the hose roll in the required length for
each transition piece.
2 Slightly loosen the clamping screws (1)
on the clamping plate using a Torx
screwdriver.
3 Insert the ends of the hoses into the
transition pieces (2) up to the stop.
NOTE: If it is too difficult to insert the
hoses, use silicone spray on the outside
of the hose.
4 Tighten the clamping screws (1).