31
If the implement type PS TWIN is selected in the basic settings (see Point 5.2), an extended Task
Controller menu is available. It is described under Point 7.1.2.
6.3.7
EMPTY HOPPER
In this menu, the residual seed can be emptied out of the hopper.
CAUTION!
CAUTION: before emptying, the calibration lid must be removed and the calibration bag must be
attached (see operating manual for the seeder).
Figure 27
Description of the button functions
With the STOP button, emptying is terminated and you remain on the same screen.
With the ESC button, the emptying is terminated and you automatically go back one menu
level; in this case, to the Set menu.
If this button is pressed and held for 2 seconds, the emptying procedure is started and
the seeding shaft rotates at 100%.
If the implement type PS TWIN is selected in the basic settings (see Point 5.2), an extended Empty
hopper menu is available. It is described under Point 6.3.7.
Description of the display elements
Indicates that the emptying procedure has been started.
If your implement is also equipped with a calibration button, the message "Actuate calibration button!"
appears. When the calibration button is then actuated, the seeding shaft rotates at full speed.
Summary of Contents for ISOBUS M2
Page 54: ...54 NOTES ...
Page 55: ...55 NOTES ...
