APS LSC, Installation & User Manual

Page: 6 / 16

6
LSC
Installation
Before commissioning the unit you are recommended to check the installation with the aid of
the check list for installation/fault finding.
Before switching on the voltage supply and the supply for the inputs and outputs you must
ensure that the voltage values are within the permissible limits (see Technical Data). Voltage
which is too high or false polarity of the voltage can lead to damage of the LSC System.
After switching on the voltage supply of the LSC System (system voltage) the green LED
"POWER ON" on the Basic Module must light up. If this is not the case, then the system
voltage is outside the permissible range. If you use more than one device (e.g. two BM and
one RM) you need to set the module addresses as explained below.
Then every individual function of the LSC System must be checked. In doing so, not only
must the configuration of the system be verified but also the external wiring and the
interaction with connected equipment. Before testing take precautions that a (possibly
inadvertent) activation of the outputs in association with equipment connected to them cannot
lead to dangerous operating states. When testing, all inputs must be systematically activated
in turn and the reaction of the system checked for its correctness.
Setting the module ID-address:
Please refer to the following points to set the module ID-addresses:
o
Turn off the supply voltage of the module.
o
Press and hold the lamp-test button, meanwhile turn on the supply voltage.
o
The actual module address is now showed as follows:
-All LED are activated for stand alone (factory setting)
-One of the LED 1 to 8 blinks (ID already set).
o
Release the lamp test button and press it again to set the ID address. With every
pressing the address counts one up, shown by the appropriate blinking LED.
o
Press and hold the lamp test button for 3 seconds to save your settings. After
successfully saving your changes, the module acknowledges with a beep tone and
switches back to operation mode.
Lamp test button