CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright
2006
by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
FC200 SERIES OPERATIONS MANUAL
4 - 14
FC200-000-02.2
Program Memory Procedures (Programming)
Use the procedures in this section to program the three memories: M1, M2, and M3.
Each program has three stored parameters: voltage, frequency, and current limit.
Note: The System Parameters (described in the previous section) take precedence
over any parameters stored in program memories.
Output Voltage
Output Frequency
Current High Limit
Setting Memory Parameters
Begin in the RESET (standby) mode. The indicator above the OUTPUT/RESET
button on the Voltage Display should be OFF. To set the desired parameter
values for voltage, frequency, and current limit, press the
︿
or
﹀
buttons on the
respective displays.
Check to make sure the values are what you want to store, then
Press and hold the M-button (1, 2, or 3) for the memory in which you want to
store the displayed parameters. The indicator above the selected M-button will
flash. When the flashing stops, release the button. The parameter values are now
stored and ready for recall.
Note:
Nothing will be stored if you release the button
while the indicator is still flashing.
NOTE: When the PLC External Interface Option is installed there are seven
memories available
M1~M7.
Follow the instructions above using the buttons
indicated in the table below for storing parameters in M1
~M7.
M1
M2
M3
M1
X
M2
X
M3
X
M4
X
X
M5
X
X
M6
X
X
M7
X
X
X
