APS APS-1000 Series, Operation Manual

Page: 49 / 75

CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright

2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-1000 Series 4 - 18 OM-001-01000-000-04.0
Error messages are displayed because of the following conditions:

Fail Under voltage occurred during startup

OCP Output current exceeded 110% of units maximum-rated value

Hi-A Output current exceeded the set current high limit value

LoDC Inverter power supply voltage less than 80% of internal bus voltage

HiDC Inverter power supply voltage greater than 120% of internal bus voltage

AcLP Input power was interrupted and then resumed

FUSE Fuse opened

Igbt Insulated Gate Bipolar Transistor (IGBT) overloaded

OtP System's critical temperature was exceeded

OVP Output voltage was high

LVP Output voltage was low

OPP Output power was high