CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright
2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-1000 Series
4 - 16
OM-001-01000-000-04.0
Error Messages
Why are there Errors?
Setup mistakes happen. Overloads occur. Systems under test fail. When the APS-1000
unit encounters a fault condition, an error has occurred. The result is:
The front panel display presents a message.
The output turns OFF.
An alarm sounds.
The “FAIL” LED flashes.
The “PROTECT” LED lights
CAUTION
Any error message signifies a fault was detected in the system or in the
operating environment. Please carefully record the error message. The error
MUST be resolved before resuming operation. If you are unable to resolve
the error, please contact APS or the distributor for service. Contact
information is found on page "
v"
of this manual.
Clearing an Error
Press RESET (once) to disable the alarm.
Make a note of the error message.
Re-read the CAUTION (above)
Refer to following
Error Message Table
.
Refer also to the more detailed explanation of error messages in the Error Message
Section.
Press RESET (again) to clear the error message and return to RESET (Standby)
status.
If you are unable to resolve the difficulty, please see page
"v"
of this manual for
APS contact information.
